HP-UX Minimal OS Installation

HP-UX Minimal OS Installation

To cold-install HP-UX 11.0, you must have the following:

A supported HP 9000 server or workstation (see Appendix A)

64 MB memory, minimum

128 MB swap space, minimum 
2GB root disk volume, minimum

You will need the following CD’s ready:

HP-UX 11.0 Install/Update/Recovery CD, March 2001 or later. 
Core OS Options CD (for technical servers and workstations). 
Support Plus CD, March 2001 or later (for hardware/critical patch bundle, diagnostics and iCOD product), is needed.

HP-UX 11.0 Application Software CDs

1. ____ Make sure all peripherals are turned on.
2. ____ Turn on the server or recycle the power.
3. ____ Load the Install and Core OS CDROM into the CD-ROM driver.
4. ____ Interrupt the autoboot process, by pressing any key during the 10 second interval that is given. This is so the system can be booted from the Core OS CDROM.
5. ____ Once autoboot was been interrupted you should now see the autoboot menu.
6. ____ Boot from the device that contains the Core OS CDROM. Usually the alternative boot path is the CDROM drive. 
   But to verify that you can type search and view all defined boot devices. 
   bo alt OR bo
7. ____ You should now be asked: Interact with IPL (Y or N) ?> Type n.
8. ____ The install kernel will take 3-5 minutes to install.
9. ____When that has completed a screen will appear asking for the keyboard language of the console. Respond with the correct number and press ENTER.
10. ____ The Welcome to Ignite-UX screen will be displayed.
11. ____ Tab to Install HP-UX field and press Enter.
12. ____ From the User Interface and Media Options screen, verify that these choices are selected: 
    Source Location Options: Media-only installation – installing from the local CD drive.
    User Interface Options: Guided Installation – provides an install wizard with limited choices.
13. ____Now proceed through each screen to configure your system: 
    Basic Configuration: Commercial Servers – this will install HP-UX 11.0 Core OS software, required ACE patches, general recommended core (XSWGR1100), latest hardware-enablement and critical (HWCR) patches, diagnostic products and COD Client Product for HP-UX 11.0 
    Software Selection: Select needed mass-storage and networking I/O driver products.
    Languages: Click the Languages button to view CDE-languages bundles to be loaded. Global is set by default when installing on workstations, resulting in all available CDE-language bundles being installed. Global (Non-CDE) is set when installing on servers to indicate that a generic, CDE-language bundle will be installed.
14. ____ Review any messages that Ignite-UX encountered. Resolve any errors before continuing with the installation.
15. ____ Select: Finish
16. ____ The system will now configure the disk(s) and load a minimum set of commands and libraries. Software Distributor will  download all the products and patches from the CD.
17. ____ As prompted, replace the HP-UX 11.0 Install/Update/Recovery CD with the requested CD from the media box.
18. ____ The system will automatically reboot after all software has been loaded.
19. ____ Set_parms will run and asked you to set

root password

date,

time,

time zone,

IP address

other network parameters.

Helping  Other  People  Excel

Share this

ChinniLax